Issue: Vol. 5 No. 1 (2022): NAPAS New Edition Online | Section: Original Article

Optimal Design of Rectifying Double Sampling Plan with Inspection Errors

Authors

  • Iorkegh Simon Tyozua
    Department of Statistics, University of Ilorin, Ilorin-Nigeria


  • Osanaiye Peter
    Department of Statistics, University of Ilorin, Ilorin-Nigeria



Abstract

In this paper, the effect of type I and type II inspection errors on the performance measures of rectifying the double sampling (RDS) plan is investigated. An economic model to determine the optimal sampling plan developed by Hsu and Hsu (2012) is extended to rectify the double sampling (RDS) plan and modified to incorporate inspection error. An optimal sampling plan that minimize the total cost and satisfied both the producer’s and the consumer’s risk requirement in both the existing model and the modified model is determined. Comparison between the optimal sampling plans of the RDS plan in the existing model and the modified model showed that the optimal RDS plan in the modified model exhibited a higher probability of acceptance of 0.9030, smaller sample sizes of n1=10, n2=20, Average Total Inspection of 113.69 and Total cost of 448.45. Whereas the existing model showed a lower probability of acceptance of 0.8891, bigger sample sizes of n1=96, n=192. Average Total Inspection of 237.32 and Total cost of 534.43. It is therefore found that the modified model performed better and is more economical in terms of cost than the existing model.

Published: 2022-05-01

How to Cite

Iorkegh ST, Osanaiye P, (2022). Optimal Design of Rectifying Double Sampling Plan with Inspection Errors. Nig Annals of Pure & ApplSci. 5(1):225-239.
DOI:10.5281/zenodo.6513568



License

Copyright (c) 2022 ST Iorkegh , P Osanaiye

Creative Commons License

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.